Breast pump accessories typically include:
Breast shields or silicone inserts for flanges: This is the part that goes over the breast and nipple, and creates a seal to allow for milk extraction.
Connectors and valves: These pieces connect the breast shields to the tubing and motor, and allow for the flow of milk into the collection container.
Tubing: This part connects the motor to the breast shields and allows for the suction and extraction of milk.
Collection containers: These can be bottles or bags that are used to collect the expressed milk.
To maintain and clean your breast pump, follow these steps:
Wash your hands thoroughly before handling any pump parts.
Disassemble the pump and rinse all parts that come in contact with breast milk under running water.
Wash pump parts in warm, soapy water or in a dishwasher (if they are dishwasher safe). Use a brush to clean hard-to-reach areas.
Rinse all parts thoroughly with water and allow them to air dry on a clean towel.
Store the pump and accessories in a clean, dry place.
It's important to note that some breast pump parts, such as tubing and breast shields, may need to be replaced periodically to ensure the pump is functioning properly and to prevent contamination. Check the manufacturer's recommendations for when to replace parts.
Duckbill valves and diaphragms are common accessories in breast pumps. Here are their functions and maintenance methods:
Duckbill Valve: The duckbill valve silicone is a small accessory in the breast pump that is usually installed at the bottom of the breast cup. Its function is to prevent milk from flowing back into the suction tube, and it can also control the suction strength. If the duckbill valve fails, it can lead to weak suction and decreased pumping efficiency.
Maintenance method for the duckbill valve: After each use, remove the duckbill valve and clean and disinfect it with warm water. It is recommended to replace it every month to ensure stable suction strength.
Diaphragm: The diaphragm is another important accessory in the breast pump that is installed between the breast cup and suction tube. Its function is to generate negative pressure during pumping, thereby extracting milk. If the diaphragm is damaged or has excessive dirt, it can affect pumping efficiency.
Maintenance method for the diaphragm: YF silicone breast pump supplier suggests that after each use, remove the diaphragm and clean and disinfect it with warm water. It is recommended to replace it every month to ensure stable suction strength. When disassembling or replacing the diaphragm, be careful not to lose the accompanying small spring.
English
